Logo

U1716 Engine Code Repair

Meaning of U1716 engine trouble code is a kind of network trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

U1716 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for U1716 code is occuring now you should check U1716 repair processes.
Now don't ask yourself; What should you do with U1716 code ?
The solution is here :

U1716 Possible Solution:

U1716 Engine

Air Conditioning Pressure Sensor (ACP) Insufficient Pressure Change Each time the A/C clutch engages, the PCM is looking for a pressure change in the refrigerant. If the change in pressure is outside of the calibration the DTC will set. A/C system mechanical failure Open ACP or VREF circuit A/C sensor damaged A/C system electrical failure A/C clutch always engaged Verify A/C system function, including refrigerant charge.

U1716 Code Meaning :

U
OBD-II Diagnostic Network (U) Trouble Code For Engine

1
Fuel And Air Metering

7
Fuel Temperature Sensor B Circuit Range/Performance

1
Cold Start Injector 1 Malfunction

6
Crankshaft Position Sensor B Circuit Malfunction

Regarding the U1716 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

U1716 OBD-II Diagnostic Network (U) Trouble Code Description

U1716 engine trouble code is about Crankshaft Position Sensor B Circuit Malfunction.

Main reason For U1716 Code

The reason of U1716 OBD-II Engine Trouble Code is Fuel Temperature Sensor B Circuit Range/Performance.

U1716 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.